Sound Test Online

Spiele den Stereo-Test ab und prüfe jede Seite.

Ja, erlaube Mikrofonzugriff, um Pegel und Peak zu sehen.

Er hilft, Verzerrungen oder fehlende Frequenzen zu hören.

Weißes Rauschen hat gleiche Energie bei allen Frequenzen und klingt "zischend" wie TV-Rauschen. Rosa Rauschen hat gleiche Energie pro Oktave, was für menschliche Ohren ausgewogener klingt und dem Frequenzspektrum typischer Musik näher kommt. Rosa Rauschen wird oft für Audio-Kalibrierung und Lautsprechertests verwendet, während weißes Rauschen nützlich ist, um hochfrequentes Zischen zu hören oder spezifische Audioprobleme zu erkennen.

Wenn du Frequenzen unter 80-100Hz nicht hören kannst, können deine Lautsprecher oder Kopfhörer wahrscheinlich keinen tiefen Bass wiedergeben. Laptop-Lautsprecher und kleine Ohrhörer geben typischerweise keine Frequenzen unter 150Hz wieder. Bass erfordert größere Lautsprechertreiber oder Kopfhörer mit guter Tieftonwiedergabe. Subwoofer sind speziell für die Basswiedergabe (20-80Hz) konzipiert. Der Frequenz-Sweep-Test hilft dir, die niedrigste Frequenz zu bestimmen, die deine Audiogeräte klar wiedergeben können.

To do a quick sound check, click the 'Left channel' or 'Right channel' button on this page. If you hear clear audio from the correct speaker, your sound is working. You can also use the frequency sweep to test bass and treble response, or the noise generators for a full-range sound check. No software installation is needed; this sound test runs entirely in your browser on any computer, laptop, or mobile device.

Yes, this tool works as a headset test for any wired or wireless headset. Plug in or pair your headset, then use the left/right channel buttons to verify both ear cups produce sound. The stereo test confirms channels aren't swapped. You can also test your headset's built-in microphone using the mic monitoring section. Works with gaming headsets, Bluetooth headsets, and USB headsets on any platform.

To test if your speakers are working, click the play buttons on this page to send test tones to your left and right speakers individually. If one speaker is silent, check your cable connections, audio balance settings, and make sure the correct output device is selected in your system settings. The frequency sweep can also reveal if your speakers have limited range or distortion at certain frequencies.

To test bass on your speakers, use the 60Hz preset button in the sine tone section, or run the full frequency sweep starting from 20Hz. If you can't hear frequencies below 80-100Hz, your speakers have limited bass response, which is typical for laptop speakers and small desktop speakers. A subwoofer or bass-capable headphones should clearly reproduce frequencies down to 40-60Hz. Listen for distortion at low frequencies, which may indicate a damaged speaker driver.

One-sided audio is usually caused by: 1) A loose or damaged headphone cable near the plug; try wiggling the cable. 2) An incorrect audio balance setting in your system; check System Preferences or Windows Sound settings. 3) A faulty headphone driver or speaker. Use our left/right channel test to confirm which channel is affected. If the correct channel plays when you press 'Left' or 'Right', the problem is in your hardware, not the audio signal.

Yes, this sound test works on mobile browsers including Chrome for Android and Safari on iOS. Connect your headphones or earbuds and use the left/right channel buttons to test stereo separation. The frequency sweep also works on mobile. Note that the microphone test may require additional browser permissions on mobile. For the most reliable results, use Chrome on desktop with wired headphones.